Winlink HF Modems: Pactor, VARA HF and ARDOP Compared

Winlink sends e-mail over amateur radio. A station writes a message on a computer, a radio modem turns it into sound, the transmitter sends it to a gateway on the other side of the country or the world, and the gateway delivers it to the internet. The message reaches the recipient as an ordinary e-mail, which is why the system is a mainstay of emergency communications, sailing and travel. The part in the middle, the modem, decides how fast the message goes, how much it costs to start and what computer you need. Three modems dominate on the HF bands: Pactor, VARA HF and ARDOP. This guide compares the Winlink HF modems so that you can choose one that fits your station, your budget and your use.
What the Modem Does
An HF channel is difficult. Signals fade, noise comes and goes, and other stations interfere. A modem for Winlink does more than turn bits into tones. It splits the message into packets, adds error correction, asks for repeats when a packet fails and adapts its speed to the quality of the channel. When the conditions are good, it uses fast and wide modulation, and when they are bad, it falls back to slow, robust modulation that gets through. The result is a reliable transfer of a message of several kilobytes, even on a weak band. The general background on the Winlink network and the guide to radio email over HF, gateways and modes explain the whole system. Here the focus is on the modem layer, which you choose and which must match the gateway you want to use.
The Three Main Choices
Pactor is the oldest of the three in wide use. It is made by one manufacturer, and it is implemented in dedicated hardware modems that sit between the computer and the radio. Pactor has several generations, with the newer ones faster. It is known for its robustness, and for a long time it was the standard for serious users, especially on ships and at remote stations. The disadvantage is cost: the hardware modem is the most expensive of the three options.
VARA HF is a software modem written for Winlink and other applications. It runs on a computer, uses the sound card to produce the signal and is typically the fastest of the common modems in good conditions, with a free version that runs at a reduced speed and a paid licence that unlocks the full speed. Its main limitation is the platform: it is primarily designed for Windows, with workarounds for other systems.
ARDOP is an open modem, which is available as free software and runs on several platforms. It is slower than VARA HF and Pactor in good conditions, and it is valued for being open, for its cost of zero and for its availability on small computers and different operating systems. It is a sound choice for beginners, for experiments and for portable or Linux-based setups.
Side-by-Side Comparison
| Feature | Pactor | VARA HF | ARDOP |
|---|---|---|---|
| Type | Hardware modem | Software modem | Software modem |
| Cost | Highest: you buy the modem | Free at low speed, paid licence for full speed | Free |
| Speed in good conditions | Fast with the newest generations | Usually the fastest of the three | The slowest of the three |
| Weak signals | Very robust | Robust, adapts to conditions | Robust but slower |
| Computer | Any that Winlink software supports, with a serial or USB link to the modem | Mostly Windows | Several platforms |
| Radio connection | Audio and PTT through the modem | Sound card interface | Sound card interface |
| Gateway coverage | Large number of gateways | Large and growing | Fewer gateways |
The numbers on speed depend on conditions, the bandwidth in use and the version, so use the table as a ranking and not as a promise. Always check the current specifications of the modem and the gateways in your region before you buy.
Gateways Decide Which Modem You Can Use
Winlink works through gateways, called RMS stations, that listen on specific frequencies with specific modems. A message can be exchanged only if your modem matches the gateway’s. A gateway that supports only Pactor cannot be used with a VARA HF station, and the reverse. Before you choose a modem, look at the list of gateways in your region and the modes they offer. A station in Europe, for example, can often find gateways for all three, but the number differs by band and by country. The list is shown in the Winlink software and on the system’s web pages, and it includes the frequency, the mode and the distance from your location. Use a propagation tool, such as in the guide to VOACAP and prediction tools, to select the gateways that your signal can reach at the time of day you plan to connect.
What You Need to Start
- A computer. Windows is the most common platform for the main Winlink client, which is the simplest way to start. For VARA HF a Windows computer is the normal choice. ARDOP can run on a wider set of systems.
- A transceiver with a digital connection. Any HF transceiver that can connect to the computer for audio and push-to-talk will do. A radio with a built-in USB sound card is the easiest.
- An interface. For software modems you need audio from the radio to the computer and back, with a way to key the transmitter. The article on digital interfaces, sound cards and ground loops explains the isolation that avoids hum, and the guide on virtual audio cables is useful when several programs share the sound card.
- An antenna that works on the bands of the gateways. A dipole or a vertical on 80, 40 and 20 metres covers many gateways, and a better antenna means a faster and more reliable link.
- A licence and a Winlink account. You need an amateur licence, as with any use of the bands, and a callsign registered with the system.
Choosing: Three Typical Situations
You are starting out and want to try it at low cost. Choose VARA HF in its free mode, or ARDOP. Both need no hardware beyond the interface you may already have for other digital modes. If you use Windows, VARA HF in the free version gives you a taste of the system. If you use Linux or a small computer, ARDOP is the straightforward choice. In both cases, the limiting factor will be your antenna and the choice of gateway, not the modem.
You send messages regularly and the speed matters. Look at VARA HF with a licence, which is usually the fastest option in good conditions, and at Pactor if you already own the modem or need its specific features. If you send large attachments, speed is worth paying for, since the time on air is expensive on a shared band.
You are preparing for emergencies or travel. Check which modem your team or your region uses, and make sure that you can work with it. In an emergency network, a common setup is more valuable than the last bit of speed. The article about HF radio blackouts is a reminder that conditions can change quickly, so a flexible set-up with two modems can be helpful.
Setting Up a Software Modem Step by Step
- Install the Winlink client and the modem. Follow the instructions for your system and note the version numbers.
- Connect the radio. Set up the audio and the push-to-talk, using the interface. Set the radio to a digital or data mode, with the filter and the processing that the modem documentation recommends.
- Set the audio levels. Adjust the output level so that the ALC of the radio does not move, since an overdriven signal spreads and the gateway will not decode it. A clean signal at moderate power is better than a loud signal.
- Select a gateway. Choose a gateway at a suitable distance, on a band that is open, and note the frequency and the mode.
- Make a test connection. Send a short message to yourself or to a test address. Watch the speed that the modem reaches and the number of retries.
- Refine. Try another gateway or another time of day, check the antenna and the noise and repeat.
Bandwidth, Channel Use and Speed
All three modems can use different bandwidths, and the width decides how fast the data can flow and how much noise the receiver lets in. A narrow mode of 500 hertz is better for weak signals and for crowded bands, and a wide mode of 2.4 kilohertz is faster when the signal is strong. Software modems choose the speed level automatically during the connection, so you will see the speed go up and down as the fading changes. Some modems let you limit the bandwidth, which is useful when the rules of a band limit it. A good habit is to start with a narrow bandwidth for the first test and to widen it when the link is stable. Remember that a faster transfer also means less time on the frequency, which is kinder to other users. It is better to send one compact message in two minutes than to occupy the channel for a quarter of an hour with a large file.
Practising Before You Rely on It
Do not wait for an emergency to learn the system. Use a dummy load for the first tests of the audio chain, so that you can set the levels without radiating, and then make a few real connections on different days and bands. Keep notes: which gateways worked, at what time, with which speed. After a month you will know the best choices for your location, and you will have a list of fallbacks. If your group has a plan for emergencies, practise it with the modem that the group has chosen, and keep a printed copy of the settings with the equipment. A system that is tested in calm weather is much more likely to work when it is needed.
Common Problems
- No connection at all. Check that the modem matches the gateway, that the frequency is correct and that your clock is accurate. Many modems depend on timing.
- Very slow transfers. The channel may be poor, or the audio level may be wrong. Try a closer gateway or a different band.
- Distortion and splatter. The audio level is too high. Reduce it until the ALC shows little or no action.
- Interference with other stations. Listen before you transmit. Gateways share frequencies with other users, and a busy channel is a bad choice.
- Noise from the computer. Switching supplies and USB cables can raise the noise floor. Use ferrites and keep the antenna away from the computer.
Rules and Good Practice
Using the amateur bands for e-mail is allowed in many countries, with conditions. In particular, the content of the messages must be consistent with the amateur service, and some countries limit the bandwidth that may be used on certain bands. Check the rules of your licence, especially for messages that are not in the interest of the amateur service. Keep the messages short, send a plain text without large attachments if you do not need them, and do not use a busy gateway for tests. Respect the frequency plan, and use the lowest power that gives a good connection, as with any digital mode.
The Bottom Line
Winlink works with several HF modems, and the choice is a matter of money, speed, platform and the gateways in your area. Pactor is a robust hardware modem that costs the most, VARA HF is a fast software modem with a free low-speed version and a paid full-speed licence, and ARDOP is an open and free modem that is slower but runs on many systems. Check that your modem matches the gateways that you can reach, build a clean audio chain and keep the power moderate. Start with a software modem, learn the system and decide later whether the speed of a paid modem is worth it for the traffic that you handle.
Frequently Asked Questions
Which Winlink HF modem is best for a beginner?
VARA HF in its free mode or ARDOP. Both are software modems, so there is no extra hardware to buy, and both can reach many gateways.
Is Pactor still worth buying?
It depends on your use. It is robust and has wide gateway coverage, but the hardware modem is costly, and a software modem may be enough for casual use.
Can I use VARA HF on Linux or a Mac?
VARA HF is mainly built for Windows. Some users run it through compatibility layers, but ARDOP is the more natural choice for other systems.
Do all gateways support all modems?
No. Each gateway lists the modes it supports on each frequency, and you must use a mode that the gateway offers. Check the list before you choose a modem.
How fast is Winlink over HF?
Much slower than the internet. Speed depends on the modem, the band and the conditions, and a short text message is practical, while large attachments take a long time.
Do I need a licence to use Winlink on HF?
Yes, an amateur radio licence is needed to transmit on the amateur bands, and the rules of your country on content and bandwidth apply to your messages.